Now the for the part that I think will require some of the most attention to detail, the Mouse' outer shell.

It amazes me every time I see the complexity that can be achieved using surface modelling. In my opinion this is what solidworks is really meant for.

First on my mental checklist was to warm-up with the USB Receiver.

First week back at uni after the break and I havn't done as much as i would have like to over the short two weeks.

However, it was probably for the best as when I did make a start on modeling the mouse I was held up by a small error of my own which would have caused me much more of a headache had I pushed through.